Operations Manual

TMB2105N_SVG

1. Switch Actuator

Figure 65

Loading Door Catch

The door catch must be adjusted to have sufficient tension to hold

loading door closed against force of load tumbling against it.

Proper adjustment is when 7-15 pounds [0.48-1.03 bar] pull is re-

quired to open door.

If adjustment is required, refer to Figure 66 and proceed as fol-

lows:

1. Open door.

2. Loosen acorn nut.

3. Turn door strike screw in or out as required.

4. Tighten acorn nut.

T048I_SVG

1. Door Latch

2. Door Catch

3. Acorn Nut

Figure 66

Drive Belt - Nonreversing Models

1. Remove guard from rear of tumble dryer.

2. To adjust belt tension, loosen idler housing bolts holding idler

housing assembly to the guide rails.

3. Position housing assembly by turning adjusting bolt until

proper belt tension is reached, then retighten idler housing

bolts.

4. Replace the guard on rear of tumble dryer.

TMB2412N_SVG

1. Poly V-Belt (Self-Adjusting)

2. Idler Housing Bolts (2)

3. Adjusting Bolt

4. Drive V-Belt

5. Idler Housing Assembly

Figure 67

Drive Belt - Reversing Models

Refer to Figure 68 .

Adjustments

DO NOT COPY or TRANSMIT

92 Part No: 70457901ENR14