Operations Manual

Fun

ctio

n OPL Coin

4 Empty ON ON Always ON

5 Empty ON ON Always ON

6 Buzzer Timer ON ON 5 Sec=Off; Continuous=On

7 Safety Tumble (OPL) or Coin

Count/Pay (Coin)

ON OFF #1 #7 DIP SWITCH

OFF ON SAFETY TUMBLE

OFF OFF NO SAFETY TUM-

BLE

ON ON COIN COUNT

ON OFF PAY

8 Programming OFF OFF Disable=Off; Enable=On

DIP Switch Functions Explained

1. Tumble dryer Type: This DIP switch selects the type of tum-

ble dryer, i.e., OPL or Coin.

2. Temperature Units: Selects ºF or ºC for the temperature dis-

play. Factory setting is for ºF.

3. Local/Remote Reversing: Preset at the factory; usually for lo-

cal reversing. Remote reversing for use with Reversing Timer

Board only.

4. Empty: Preset at the factory; always ON.

5. Empty: Preset at the factory; always ON.

6. Buzzer Timer: This DIP switch determines the length of time

that the end of cycle buzzer will remain on. “OFF” indicates

that the buzzer will sound for 5 seconds when the drying cy-

cle is completed. “ON” indicates that the buzzer will sound

continuously until the STOP button is pressed or the loading

door is opened.

7. Safety Tumble (OPL) or Coin count/Pay (Coin): If DIP

switch #1 is set for OPL, then DIP switch #7 in the ON posi-

tion enables the safety tumble. If DIP switch #1 is set for

Coin, then DIP switch #7 in the ON position enables the dis-

play of the coin count. DIP switch #7 in the OFF position ena-

bles the display of “PAy”, to indicate that coins are needed to

run the tumble dryer.

8. Programming: This switch enables or disables the program-

ming feature and should normally be in the OFF position.

DMP Coin

DV and DX Control Suffixes

Operating Instructions

DO NOT COPY or TRANSMIT

84 Part No: 70457901ENR14