Operations Manual

TMB2328N_SVG

1. Gas Shut-Off Valve (Ahead of pressure tap) (Shown in

open position) (Not Supplied)

2. Pressure Tap

3. Gas Shut-Off Valve (Shown in closed position) (Not Sup-

plied)

4. Specified Local Inlet Pressure

Figure 15

Specific Conversion Procedures

How to Convert Gas Valve from Regulated to Unregu-

lated

NOTE: Conversion from regulated to unregulated is on-

ly needed when regulated tumble dryers were ordered,

but unregulated tumble dryers were needed.

1. Disconnect electrical power from tumble dryer. Close gas

shut-off valve to tumble dryer. Refer to Figure 15 .

2. Follow instructions in Conversion Kit, Part No. M400763.

NOTE: These kits do not contain any burner orifi-

ces.

3. Replace burner orifice(s) as per Table 1 .

4. If applicable, peel off the appropriate conversion sticker (in-

cluded with tumble dryer) and apply it to the serial plate over

the “ADJUSTED FOR ______ GAS: ______” information.

5. Commission tumble dryer for use.

How to Change Burner Orifice Size

1. Disconnect electrical power from tumble dryer. Close gas

shut-off valve to tumble dryer. Refer to Figure 15 .

2. Remove spud holder. Unscrew spud holder nut near gas valve.

Remove the burner orifice(s) from spud holder. Refer to Fig-

ure 16 .

3. Install the new, correct burner orifice(s). Refer to Figure 17

and Table 1 . Torque each to 9 – 10 Nm.

4. Reinstall spud holder assembly to gas valve, making certain

burner orifice(s) are in line with burner tube opening. Refer to

Figure 17 .

5. Commission tumble dryer for use.

NOTE: Blank burner orifices are Part No. M400995.

Installation

DO NOT COPY or TRANSMIT

36 Part No: 70457901ENR14