User's Manual

SR3 Installation Guide
& User Manual
AN1031 V1.0 Copyright ©2019 UniKey Technologies. All rights reserved.
UNIKEY PUBLIC.
8
SR3 Reset
A reset is performed in order to clear the reader of existing organizations and corresponding
end user credentials. Access to any specified organization will need to be re-established before
continuing reader use.
1. To locate the reset button on the reader, dismount from the installation points. The reset button
is located on the back of the reader, as depicted in Figure 1.
2. Confirm that the reader is still connected to power source; The LED ring should display a solid
blue animation.
3. Hold down the reset button for a minimum of 5 seconds.
4. After the reader has successfully completed the reset, the LED ring will momentarily flash a
series of red, white, and amber blinking. Once the amber is solid, the reset is complete.
5. The reader’s enrollment has now been cleared and is ready to be enrolled at a specified
organization.
Figure 1: Reset button is located on the back of the reader between the buzzer and cable.
R
eset B
utton
Buzzer
Cable