User manual

www.unikapro.com
5
Operational Guidance
1. Phase tester - Test XLR cable
③
Switch on the power and tune level then
you will hear the click tone.
④
Shift receiver’s INPUT switch into LINE
position. Shift the same pin number
at both side then the green IN led will
be shined if the both pins are proper
soldering in symmetrically. If the red
OUT led is shining then meaning the pin
2/3 are reversed from the other side.
①
Release screws & plug in 9V PP3
Alkaline batteries.
②
Plug in XLR cable in each side.