ISH L NG E OPERATING AND MAINTENANCE MANUAL CR TROLLEYS AND BARROWS Please read this instruction booklet carefully before use.
ALLOWED EQUIPMENTS Pump COMET PUMPS ANNOVI REV. PUMPS COMBUSTION MOTORS ELECTIC MOTOTRS HOSE-REELS SPRAYGUNS WEED-KILLING BOOMS NOZZLES NOZZLE TIPS MC 20 WEIGHT IN Kg 2 CR 125P X MP 30 X “ “ MP 40 X “ “ APS 31 “ “ Pump AR 252 “ “ CR 80 2R CR 75 1R CR 70 1R CR 50P X X X X X X X X X X X AR 30 Oleo Mac 550 X X X X X CM 46 X X X X X B. & S.
20 1 2 3 4 5 21 6 19 18 17 7 16 15 9 8 10 13 14 12 11 CR 75 1 17 13 2 3 21 5 7 18 4 6 14 16 15 11 10 8 4 CR 50 3
1 17 2 3 4 5 21 8 18 7 20 19 6 9 16 15 11 10 14 12 CR 80 1 2 3 4 5 21 6 18 17 7 16 8 15 9 11 10 14 13 12 CR 125 4
2 3 4 5 21 12 22 2 23 16 24 25 OFF 26 27 ON S c d e f g b a 44 h i 11 p o n m l 5
31 43 38 29 30 + bar + psi - bar - psi 32 33 39 33 28 42 31 29 30 28 31 43 36 29 30 32 42 34 40 38 37 32 34 36 37 38 41 33 40 41 33 39 39 28 29 30 31 41 40 40 42 38 42 35 32 42 34 29 40 31 29 32 33 34 35 36 37 38 - bar - psi + bar + psi 42 PRESS 30 BY-PASS OFF 39 40 6 36 41 ON
13 12 1 16 4 22 13 4 1 16 12 5 7
SUMMARY PART ONE 1. GENERAL INFORMATION _______________________________________9 1.1 TERMS OF THE GUARANTEE..................................................................................9 1.2 THE ADDRESS OF THE MANUFACTURER..........................................................10 1.3 USE AND CONSERVATION OF THESE OPERATING AND MAINTENANCE INSTRUCTIONS ................................................................10 1.4 SYMBOLS .........................................................................
INTRODUCTION This manual is divided into two separate sections. The first is for use by the end user and the Skilled Technician; the second is for use by the Skilled Technician alone. Skilled Technician means a person, generally employed by the service centre, who has received appropriate training and is authorised to carry out special maintenance and repairs on the appliance (the term “appliance” is used to indicate both trolleys and barrows).
back to the Manufacturer within 10 days of the purchase date with all its parts filled in. The purchaser has sole right to the replacement of the parts that are deemed faulty by the Manufacturer, or by his authorised representative, as regards their material or manufacture. This does not imply any right to compensation for any type of direct or indirect damage. Any costs for labour, packing and transportation are at the purchaser’s expense.
instructions are also given to the new owner. We take great care when drawing up our instructions. If you note any mistakes, please do inform the Manufacturer or an authorised service centre. The Manufacturer reserves the right to modify, update and correct these instructions without notice. It is illegal to copy these instructions, even partially, without prior authorisation by the Manufacturer in writing. 1.
altitude and the room temperature increase (the drop is approximately 3.5% for every 305m / 1000 ft above sea level and 1% for every 5.6°C/42°F above 16°C/61°F). Refer to the combustion engine’s instructions for any precautionary steps to take if the appliance is to be used at high altitudes or at high room temperatures. Refer to figures 1, 2, 3 and 4 located at the start of these operating and maintenance instructions for the following. 2.1 2.1.1 2.1.2 2.
2.3 IDENTIFICATION LABEL AND WARNING LABELS CAUTION • If one or more identification labels or warning labels deteriorate during use, contact your dealer or an authorised service centre so they can be replaced. • The identification label for the barrow/trolley (6) must be attached to the base (9) by the Skilled Technician a) Identification label for the barrow/trolley The identification label (6) gives the barrow/trolley’s model name, its weight when empty, its tank capacity, and the year of manufacture.
2.4 STANDARD ACCESSORIES Check that the product purchased is made up of the following parts: • barrow/trolley with the chosen motor-driven pump; • hose reel (if this optional has been chosen); • lever lance with standard nozzle (1.5mm Ø); • operating and maintenance instructions for combustion engine, if any. • operating and maintenance instructions for barrow/trolley; • guarantee certificate. Please contact your dealer or authorised service centre if there are any problems with the above. 2.
• The appliance must not be used to wash people, animals, energized electrical appliances, delicate objects or the appliance itself. • The accessories (standard and optional) used with the appliance must be those endorsed by the Manufacturer. • The appliance is not suitable for use: - in situations where certain conditions may be found such as in corrosive or explosive atmospheres; - in a closed space if it is fitted with a combustion engine.
PUMP OPERATING PRESSURE PRESSURE ACCUMULATOR INFLATION bar psi bar 2-5 29-73 2 psi 29 5-10 73-145 2-5 29-73 10-20 145-290 5-7 73-102 20-40 290-580 7 102 e) Check the external intake filter (5) is clean (only for CR 75, CR 80 and CR 125). WARNING • Make sure ice has not formed inside the pump, hoses and tank if the appliance is used in very low temperatures. • The routine maintenance checks must be carried out, particularly those concerning the oil. 4.1.
WARNING • For electric appliances with three-phase motors, particular attention must be paid to ensure the direction of rotation of the motor corresponds to that shown on the reducer. If this is not the case, contact a Skilled Technician who will be able to solve the problem by simply inverting a wire inside the power plug. Failure to comply with the above will result in considerable damage to the appliance. 4.1.
4.2 SPRAYING CAUTION • Pay particular attention to the instructions contained in the section on “Preparing chemicals for spraying”. • While you are spraying, avoid spraying the product on buildings, houses, public or private land, gardens, roads, public or private courses of water and areas used by people or animals. Spraying in close proximity of these areas must be carried out when it is not windy.
a) b) c) d) e) f) • Follow the instructions in the “Switching off” section: - when the appliance is not is use; - before leaving the appliance unattended, even for a short time; - before topping up the chemicals; - after use; • Do not remove the plug from the power outlet by pulling on the power supply cable. • Keep the power supply cable, any extension cords, the plugs and the outlets dry. Do not touch them with wet hands.
g) Operate the lever (26) on the lance (13) to achieve the required spraying angle (from an empty cone to a needle-point jet). The adjuster (24) can be used to fix the preferred position for spraying. We recommend this is done while spraying with the lance into the tank to avoid wasting chemicals. The flow rate of the sprayed liquid depends on the operating pressure, the nozzle (27) used (the 1.5 mm Ø nozzle is supplied as standard with the appliance) and the adjustment of the spray angle.
• Pay particular attention to the instructions contained in the section on “Preparing chemicals for spraying”. • Only start cleaning and maintenance once the instructions in the ‘Switching off’ section have been completed, i.e. when there are no moving parts on the appliance, there is no pressurised liquid in the hoses and the appliance has cooled down completely.
6.2 ROUTINE MAINTENANCE Follow the instructions in the “Switching off” section and in the table below. For appliances fitted with a combustion engine, remember to follow the instructions for routine maintenance in the engine’s operating and maintenance instructions, especially as regards controlling the engine oil, the air filter and the spark plug. INTERVAL FOR MAINTENANCE Each time used ACTION Check level and status of pump oil Check the intake filter, filling filter, and nozzleand clean, if necessary.
diaphragm rupture, we recommend you drain the pump crankcase of the mixed oil and pumped liquid and then fill it with oil or diesel to prevent the formation of rust. • The following are frequently the causes of diaphragm rupture: - bottlenecks in the intake circuit (inadequate hose section, very dirty filter, very dense liquid being pumped, etc) - the use of very aggressive chemicals 6.3 SPECIAL MAINTENANCE CAUTION • Only Skilled Technicians are authorised to carry out special maintenance.
8. DISMANTLING AND DISPOSAL Only trained personnel are allowed to dismantle the appliance in accordance with the current regulations in the country where it is installed. CAUTION • Before disposing of the appliance, make sure it is no longer possible to operate it, by cutting the power supply cable for example. Make sure all its parts are now inoffensive, as they could prove to dangerous to children playing. 9.
PART TWO (only for use by Skilled Technicians) CAUTION • This part of the manual is only for use by Skilled Technicians and is not meant to be used by the end user of the appliance. 1. REMOVING THE APPLIANCE FROM ITS PACKING MATERIALS CAUTION • Protective gloves and glasses must be worn when removing the appliance from the packing materials to prevent injury to the hands and eyes. • The packing materials (plastic bags, staples etc.) must not be left in reach of children, as they are potentially dangerous.
g) Check the inflation pressure of the pressure accumulator and the tyres. h) Check the level of the pump oil and reducer oil. i) For appliances fitted with combustion engine, fill the crankcase with oil as the engines are supplied without oil. j) Carry out a test with clean water before giving the appliance to the end-user. 2.1 MOUNTING THE HOSE REEL (OPTIONAL) a) b) c) d) Pre-assemble the hose reel using the specific assembly instructions provided.
SUMMARY PART ONE 1. GENERAL INFORMATION _______________________________________9 1.1 TERMS OF THE GUARANTEE..................................................................................9 1.2 THE ADDRESS OF THE MANUFACTURER..........................................................10 1.3 USE AND CONSERVATION OF THESE OPERATING AND MAINTENANCE INSTRUCTIONS ................................................................10 1.4 SYMBOLS .........................................................................
UNIGREEN ® S.p.A. via Rinaldi, 105 - 42100 REGGIO EMILIA - ITALY Tel. (0039) 0522 369811 Fax. (0039) 0522 369898 e-mail info@unigreen-spa.com internet www.unigreen-spa.com member of the YAMA group Decrizioni, illustrazioni indicative, UNIGREEN S.p.A.si riserva la facoltà di apportare variazioni o modifiche senza preavviso.
