User`s guide

Appendix B-8
GSIOC Control Appendix B
GSIOC Commands
Example 4: to restore display messages
This sequence sends “reconnect”
commands to the internal software
for the two related output devices.
Original messages are restored. In the
case where a separate access to the
two lines of the display is not required,
the same action is performed by a
single command as above.
Example 5: to select the flow mode, and start
pumping at 1 mL/min.
Codes sent correspond to the
following key sequence: <Menu>
<Mode> <Flow> <1> <Enter> <Run>.
The reconnect command is necessary
if a direct access to keyboard keys is
required.
Command Comment
(B) W0 Reconnect upper line to software.
(B) W1 Reconnect lower line to software.
Command Comment
(B) W Reconnect both lines to software.
(B) W1 Reconnect lower line to software.
Command Comment
(B) Kdea 1Ee Mimic key entries
(B) K Reconnect keyboard to software.