User Manual

WirelessUSB™ - UGWN2US
Solutions for a Real Time World User Manual
UM-UGWN2US 7 45388 Warm Springs Blvd. Fremont, CA 94539
[e-mail]
TEL: [phone] FAX: [phone]
http://www.unigen.com Toll Free: [phone]
Copyright Unigen Corporation, 2005
Emissions Compliance Testing
Notwithstanding the Modular Approval for the Radio Device with associated antenna, the end
product configuration must meet digital emissions compliance and must be tested in
accordance with FCC Part 15 requirements confirming radiated emissions are within specified
limits.
Applicable sections include:
• Part 15 Section 15.109 Sub-paragraph A, Class B Radiated Emission Limits
These emissions tests can be conducted by the manufacturer or by contacting an approved
test facility equipped and certified accordingly. The results of these emissions tests are not
required to be submitted to the FCC or Unigen, but should be kept on file by the OEM.
Co-location of Additional Transmitters
Digital Electronic Devices manufacturers using this MA grant should refer to Appendix B (FCC
Grant #) for end-products using two or more co-located RF transmitters. This grant states:
“ This modular transmitter is approved for use in mobile Digital Electronic
Devices. It may not be co-located with other transmitting devices that might
operate at the same time as the device. The antenna must be installed to
ensure a minimum separation distance of 20cm between any part of the
radiating structure and persons to satisfy the appropriate RF exposure
requirements contained in the FCC rules.
The end user must also be provided with these installation and operating
instructions for satisfying RF exposure requirements.
In order for this module to be operated in any configuration other than that
permitted in the preceding sentences, a separate FCC equipment
authorization must be obtained for each device into which this module is
installed.
“
This modular approval is granted provided Digital Electronic Devices manufacturers assume
responsibility for ensuring that other transmitters operating in conjunction with the UGWN2US
comply with RF exposure requirements associated with their use. The use of one or more
additional RF transmitters will require review by the FCC and may require end-product re-
certification, including the UGWN2US to ensure emissions compliance and RF safety. It is the
sole responsibility of the Digital Electronic Device manufacturer to obtain end-product
regulatory compliance for configurations including two or more RF transmitters.