User's Manual

Solutions for a Real Time World NEMO2 Design Guidelines
Applicationnote
Software and Host
Nemo2 is intended to operate with a host. The host will communicate to the module
via the physical communication interfaces, UART/SDIO, to control the modules RF
operating behavior. The host shall run the Bluetooth Upper software protocol stack
operate Nemo2 in Bluetooth modes only. Nemo2 is not intended to operate without
a host and Bluetooth protocol stack. The Nemo2 software interface is based on the
Bluetooth Host Controller Interface Transport Layer specification (HCI). For more
details on the Bluetooth HCI protocol layer, please see the latest Bluetooth
Specification (3.0+HS), volume 4 and the section pertaining to Host Controller
Interface [Transport Layer]
Figure13:NEMO2BluetoothSoftwareStackArchitecture