System information

Integrate Polycom RMX Systems with UNIFY OpenScape
Polycom, Inc. 60
Admin Tip: Configuring RealPresence Collaboration Server (RMX) 1500/4000 and
RealPresence Collaboration Server (RMX) 2000 LAN Port Modes
When configuring the RealPresence Collaboration Server (RMX) 1500/4000 platforms,
you can manually modify automatically identified speed and transmit/receive mode for
each LAN port that the system uses if required by the specific switch in the Ethernet
Settings dialog.
 Port Speed You can set the speed and transmit/receive mode manually for LAN 2 Port only.
Do not change the automatic setting of Port 1 and Port 3. Any change to the Port 1 speed will
not be applied.
 Port Choose port 1, 2, or 3
 Speed Choose the speed and transmit/receive mode for each port. The default setting is Auto
which starts at 1000 Mbps Full Duplex, proceeding downward to 10 Mbps Half Duplex. To
maximize conferencing performance, especially in high bit rate call environments, use a 1Gb
connection.
7 Click OK. If you have modified the Management Network Properties, reset the MCU.
Modify the Network Service
The Network Service parameters need to be modified if you want to change any of the following:
● The network type that the RealPresence Collaboration Server (RMX) connects to
● The IP address of the RealPresence Collaboration Server (RMX) Signaling Host
● The IP addresses of the RealPresence Collaboration Server (RMX) Media boards
● The subnet mask of the RealPresence Collaboration Server (RMX) IP cards
● The gatekeeper parameters, including additional gatekeepers you want to add to the Alternate
Gatekeepers list
● SIP server parameters
Configure the RealPresence Collaboration
Server (RMX) IP Settings
This section shows you how to configure RealPresence Collaboration Server (RMX) IP Settings.
To view or modify the Network Service:
1 In the RMX Management pane, choose IP Network Services, shown next.