System information

Integrating Polycom® HDX® Systems with UNIFY® OpenScape®
Polycom, Inc. 33
○ Enable PC LAN Port Check this box to enable the PC LAN port on the back of Polycom HDX
4000 and 4500, HDX 7000, HDX 8000, or HDX 9006 system. Disable this setting for increased
security. This option is not available on the Polycom HDX 6000 or 9000.
○ Enable EAP/802.1X Check this option to enable the EAP/802.1X authentication protocol.
Polycom HDX systems support the following authentication protocols:
» EAP -MD5
» EAP-PEAPv0 (MSCHAPv2)
» EAP-TTLS
» EAP-TLS
○ Enable 802.1p/Q Check this box to specify whether VLAN and link layer priorities are enabled.
The following optional QoS settings are available only when 802.1p/Q is enabled and only on
the web interface:
» VLAN ID Specifies the identification of the Virtual LAN. The value can be any number from
1 to 4094.
» Video Priority Sets the link layer priority of video traffic on the LAN. Video traffic is any
RTP traffic consisting of video data and any associated RTCP traffic. The value can be any
number from 0 to 7, although 6 and 7 are not recommended.
» Audio Priority Sets the priority of audio traffic on the LAN. Audio traffic is any RTP traffic
consisting of audio data and any associated RTCP traffic. The value can be any number from
0 to 7, although 6 and 7 are not recommended.
» Control Priority Sets the priority of control traffic on the LAN. You can choose a value from
0 to 7, although 6 and 7 are not recommended. Control traffic is any traffic consisting of
control information associated with a call and can include H.323, which includes H.225.0 Call
Signaling, H.225.0 RAS, H.245, Far End Camera Control, or SIP, which includes SIP
Signaling, Far End Camera Control, Binary Floor Control Protocol (BFCP).
Specify HDX SIP Settings
Once you have configured the Polycom HDX system LAN properties, specify Session Initiation Protocol
(SIP) settings to connect SIP calls using UNIFY OpenScape Voice. You can configure SIP settings using
the system user interface or the web interface. This procedure shows you how to configure settings using
the web interface.
To specify SIP Settings:
1 Do one of the following:
○ In the system local interface, go to System > Admin Settings > Network > IP > SIP Settings.
The SIP Settings display, shown next. Use to navigate multiple pages in the interface.