Specifications

administration.fm
A31003-S2030-M100-10-76A9, 01/2014
OpenStage SIP V3R3 for OpenScape Voice, Administration Manual
69
Administration
IP Network Parameters
3.3.4 IP Address - Manual Configuration
3.3.4.1 Configuration
If not provided by DHCP dynamically, the phone’s IP address and subnet mask must be
specified manually.
By default, IP configuration by DHCP and LLDP-MED is enabled. For manual IP configuration,
please proceed as follows:
1. Navigate to Network > General IP configuration. Set DHCP Enabled, DHCPv6 Enabled
and LLDP-MED to "not selected". Afterwards, click Submit.
2. Navigate to Network > General IP configuration> IPv4 configuration or IPv6 configu-
ration depending on settings in Section 3.3.2, “Protocol Mode IPv4/IPv6”. Enter the IP ad-
dress and the Subnet mask. If applicable, enter the Default route. Afterwards, click Sub-
mit.
3. After the phone’s network service has restarted, the other IP parameters can be
configured.
>
IP addresses can be entered in the following formats:
– Decimal format. Example: 11.22.33.44 or 255.255.255.0 (no leading ze-
roes).
– Octal format. Example: 011.022.033.044 (leading zeroes must be used with
every address block)
– Hexadecimal format. Example: 0x11.0x22.0x33.0x44 (prefix 0x must be
used with every address block)
LLDP-MED Enabled
DHCP lease reuse
IP address
Subnet mask
Default route
Route 1 IP address
Route 1 gateway
Route 1 mask
IPv4 configuration
192.168.1.235
192.168.1.2
DHCP Enabled
Submit
Reset
255.255.255.0
Route 2 IP address
Route 2 gateway
Route 2 mask
Global Address
Global Address Prefix Len
Global Gateway
Link Local Address
Route 1 Dest.
Route 1 Prefix Len
LLDP-MED Enabled
IPv6 configuration
DHCPv6 Enabled
DHCPv6 lease reuse
Submit
Reset
Route 1 Gateway
Route 2 Dest.
Route 2 Prefix Len
Route 2 Gateway