User manual

TD 92929EN
20 December 2013 / Ver. B
User Manual
WL3 and WL3 Plus WLAN Handset
36
6. Calling
(WSG)TD 92442EN.
TIP: Set the automatic key lock to “On”, if it is desired to h
ave key lock during an ongoing
call, see Activate the Automatic Key Lock on page 56.
6.7.1 Accept a PTT Invitation
A PTT invitation is viewed the same way as an ordinary m
ess
age. The message can contain
up to 255 characters.
Figure 5. Incoming PTT invitation
Fire alert in
building A...
Accept
12:34
Reject
1 Press “Accept”.
The handset can accept the invitation automatically, start in mute mo
de, and start in
loudspeaking mode, depending on the configuration of the received invitation.
When the invitation is accepted, you can delete or close
the invitation by clicking the
soft key “Delete” or “Close”, respectively. The call is not disconnected when clicking
these soft keys. The soft key “Re-join” is used for re-joining a group only.
2Press and hold
to open the microphone for transmitting. The microphone is
muted again when
is released.
Decline a PTT Invitation
Press “Rejec
t” to decline the invitation. The handset returns to the previously shown screen.
See also 6.7.2 Re-join a PTT Group on page 36 for more information.
6.7.2 Re-join a PTT Group
If you received a PTT invitation but rejected it, you c
an dial the PTT group by selecting the
message in the Message inbox, and then press the soft key “Call”. See figure 5 on page 36
6.7.3 Call a PTT Group
To call a PTT group, you must first connect a service or a short cut to a PTT group, see 9.5
Ser
v
ices on page 52 and 9.6 Short Cuts on page 53. Then you call the PTT group by selecting
that service or short cut.