User manual

TD 92929EN
20 December 2013 / Ver. B
User Manual
WL3 and WL3 Plus WLAN Handset
30
6. Calling
6. Calling
6.1 Incoming Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset signals a call.
Ring signal and vibrator can be disabled, see 9.7.1 Sound and Alert Settings on page 54. The
calling party’s handset information or name is shown. The local phonebook name is
displayed if the calling party’s handset number is stored in the local phonebook, else the
calling name or calling number is shown.
NOTE: When a headset is connected to the handset, the headset button can be used to
answer
the call. In addition, it is possible to configure the headset button with a
specific function, such as dial last called number, or dial a predefined number. See
Configuration Manual, WL3 WLAN Hands
et and WL3 Plus WLAN Handsetfor more
information.
Other answering keys and methods can also b
e set in the Settings menu. For example, it is
possible to set the answering behavior to any key (with exceptions). The answering
methods are; Automatically, Loudspeaking, and Quick answer.
When “Automatically” is enabled, all incoming calls are connected automatically. At “Quick
answer”, the call is connected by lifting the handset out of the charger. See 9.7.5 Answering
on page 60.
6.1.1 Answer a Call
When the signal sounds, press , “Accept” on the left soft key, or press
to answer the
call in loudspeaking mode. The name/number of the calling party is displayed, if calling line
information is available.
Secure voice transmission
NOTE: The secure voice transmission must
be activated by the administrator.
If you call a party or receive a call from a party ov
er a secure connection, the “Secure call”
icon , appears up left in the display. A non-secure call transmission is indicated by the
“Non-secure call” icon .
6.1.2 End a Call
A press on the End key or the right Soft key “End”
ends the call. The duration of the call
is shown in the display.
6.2 Outgoing Call
6.2.1 Pre-Dial
Enter the number and press or the soft key “Call” to get the
line. The number is shown
on the display while dialing. If needed, press “Clear” to erase the number. By using the
Navigation key, it is possible to step and add/delete a digit in a number.
An international number can be dialed from the ha
ndset by entering a + character followed
by the country code and local number. To enter the + character, long press the 0 key until
the character is shown in the display.