User manual

TD 92929EN
20 December 2013 / Ver. B
User Manual
WL3 and WL3 Plus WLAN Handset
7
2. Safety and Regulatory
2.3 Regulatory Compliance Statements (USA and Canada only)
FCC ID: BXZWH1
IC: 3724B-WH1
US: 9FVIPNANWH1 HA
C
2.3.
1 FCC and IC Compliance Statements
This equipment has been tested a
n
d found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the e
q
uipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la Classe B conforme á la norme NMB-003 du Canada.
Privacy of communications may not be ensured when using this handset.
2.3.2 Exposure to Radio Frequency Signals
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environm
ent. This device complies with FCC SAR limit of 1.6 W/kg. The maximum SAR value
measured when used at the ear is 1.38 W/kg. The telephone has also been tested when
worn on the body using belt clip. The maximum measured SAR value in this configuration is
1.16 W/kg. This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
Use of non-Siemens approved accessories may violate the FCC and IC guidelines for RF
exposure and should be avoided.
2.3.3 Information to User
This device complies with Part 15 of the FCC rules
and with Ind
ustry Canada license-exempt
RSS standard(s).
Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that may
c
ause undesired operation.
Le présent appareil est conforme aux règles FCC partie 15 et aux CNR d’Industrie Canada
appl
icables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1 l’appareil ne doit pas produire de brouillage, et