Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
90
15. Software Administration
15.5 Install New Software
It is recommended to always perform a backup before installing new software, see
15.5.1 Create a Software Backup. After the software installation see also 14.4 Update
the User Interface after a new Release on page 88.
Make sure that no Device Manager client is open and it is also important that no ftp
client is logged in to the module.
The information stored in the database will not be overwritten when new software is
installed.
NOTE: It is not recommended to use the module’s Management port when installing
software.
1 Click “Configuration” on the start page.
2 Select Software > Installation in the menu on the Configuration page.
3 Select software (.pkg) to upload. The software will replace the not running
software.
4 Select “Switch immediately” if you want to run the new software.
5 Select “Copy current settings” if you want the new software to inherit the settings
currently used. This selection will have no effect if the software type is different
than the currently used software. The module will always start up using factory
settings if the software type differs.
6 Click the “Start Installation” button.
15.5.1 Create a Software Backup
It is recommended to now and then create a backup of the software configuration.
1 Click “Configuration” on the start page.
2 Select Software > Installation in the menu on the Configuration page.
3 Click the “Backup” button.
Note that the backup will contain configuration for the running software only.