Specifications

TD 92442EN

04 October 2013 / Ver. PB1

Installation and Operation Manual

OpenStage WL3 Wireless Service

8. Additional System Settings

2 The following parameters can be set (some of these parameters can also be set

in the setup wizard):

• Require network connection – Controls if the module needs a connection to

the network to start up. This can be useful if you want configure the module

before connecting it to a network.

• DHCP – Controls whether static or dynamic IP address shall be assigned to

this hardware. If DHCP is enabled, only the host name below is applicable.

• IP address – Sets the IP address for the module

• Default gateway – Sets the IP address to a Gateway on the LAN

• Subnet mask – sets the network mask that is to be used. If this parameter is

set to 0.0.0.0 it means that the Gateway never will be used.

• Host name

• Domain name – Sets the desired domain name for the module

• DNS Server – Sets the IP address to a DNS if one exists. If no DNS Server is

present on the network, set this parameter to 0.0.0.0.

• WINS Server – sets the IP address to a Primary WINS Server if one exists.

• If no WINS Server is present on the network, set this parameter to 0.0.0.0.

For additional information, see also the Installation Guide for your product.

3 Click “Activate”.

8.5 Setting the License Number

The license number is normally set in the setup wizard but it can also be set on the

Advanced Configuration page.

1 Click “Configuration” on the start page.

2 Select Other Settings > Advanced Configuration on the Configuration page.

3 Under Common, click “License” in the menu on the Advanced Configuration

page

4 Enter the license number and click “Activate”.

8.5.1 Reboot

The module can be rebooted on the Advanced Configuration page.

1 Click “Configuration” on the start page.

2 Select Other Settings > Advanced Configuration on the Configuration page.

3 Under Common, click “Reboot” in the menu on the Advanced Configuration page

4 Click the “Reboot” button.

NOTE: If the Reboot page is reloaded, this will trigger another reboot.