Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
66
8. Additional System Settings
8. Additional System Settings
8.1 Unite Name Server (UNS)
The UNS in the WSG is used to resolve addresses into complete destinations. The
module can be configured to send all requests to the local UNS (stand-alone mode) or
to forward all requests to a centralized UNS (forwarding mode). In forwarding mode,
the local UNS will only be used if the centralized UNS cannot resolve the address.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration on the Configuration page.
3 Under Other, click “UNS” in the menu on the Advanced Configuration page.
8.1.1 UNS Operating Mode
Operating mode is changed in systems with a Unite CM only.
1 To set Operating mode, click “Operating mode”.
2 In a system with a Unite CM, set operating mode to Forwarding and enter the
Unite CM IP address.
3 Click “Activate”.
8.1.2 Default Category
The UNS Default Category is used to decide where messages from the WSG shall be
sent. The messaging handler is default set to localhost (127.0.0.1) which is the internal
message group handler in the module. This can be changed if you want to use a
messaging handler in another module. This parameter is changed for example if your
system is connected to another WSG.