Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
20
4. Basic Configuration
4.3 Status
On these pages, information on active faults or stored faults can be shown.
4.3.1 Active Faults
Active Faults page is where the last 100 received active persistent fault logs are listed.
For more information about the fault log, refer to 4.3.4 Fault Log on page 21.
1 Click “Configuration” on the Start page.
2 Select Status > Active Faults, in the menu on the Configuration page.
The following information is shown for each fault:
• Time when the fault occurred
• Level of the fault:
- Critical error
- Error
- Warning
• Description of the fault, as defined in the module
• Type of module
• IP address and host name of the module that generated the fault
By expanding the fault in the list, additional information about the fault is shown
containing:
•Fault ID
• This is used to reference a persistent fault when it later is reset
• Fault code
• Description of the fault code
• Extended address information showing the system, bus type and module
address
• In the figure below the system is 00, the bus type is 1 and the module
address is 0A.
Persistent faults will remain in the list until the module sends a status message
confirming that the module is working properly again. It is also possible to delete the
fault in the list by clicking the icon .
NOTE: If the IP address or license is changed in the module, the faults reported for the
previous IP
address/license will remain since no confirmation can be received.
These faults must be manually deleted.
The active faults list page has to be manually updated by clicking the “Update Page”
link uppermost on the page.
4.3.2 Reset the Error Relay
The error relay can be reset manually from the Active Faults page.
1 Click “Configuration” on the start page.
2 Select Status > Active Faults in the menu on the Configuration page.
Group description: Description of the group.
Members: Add members/handsets to the group
a.If it should be possible to send messages from a handset in the Cordless Telephone System,
the address has to be a number.