Specifications

TD 92442EN

04 October 2013 / Ver. PB1

Installation and Operation Manual

OpenStage WL3 Wireless Service

3. General

4 Enter/Select the following:

3.6 Demonstration Mode

Demonstration Mode makes it possible to run the product for two hours with almost full

functionality of the application.

The Demonstration Mode can be set from the application’s Configuration page or

manually by using the Mode button. The module will automatically return to previous

license and parameters (without restart) after 2 hours.

Demonstration Mode is indicated by the Status LED with yellow slow flashing light. If

any application encounters problems during Demonstration Mode, the Status LED will

however show red slow flashing light instead. The Mode button LED shows blue fixed

light.

From the application’s Configuration page:

1 Click “Configuration” on the start page.

2 Select Other Settings > Demonstration Mode in the menu on the Configuration

page.

3 Click “Activate”.

4 Exiting before the 2 hours have passed, is done by clicking “Deactivate”.

Using the Mode button:

1 Press and hold the Mode button for 10 seconds.

Proxy: Determines if the proxy settings below is to be used

HTTP Proxy

Address:

The address to the proxy server

HTTP Proxy Port: The port the proxy server is listening at