Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
12
3. General
3.4.2 NetBIOS Port
You can determine if the NETBIOS port (UDP 137) shall be open or closed. The
NETBIOS makes it possible to access the WSG with the NetBIOS name “elise-
XXXXXXXX”, where XXXXXXXX is the module key number. If the port is closed, only
the WSG’s IP address can be used to access the WSG.
The NetBIOS port is default enabled but can be disabled if needed for security
reasons.
6 Click “Configuration” on the start page.
7 Select Other Settings > Advanced Configuration in the menu on the
Configuration page.
8 Select “IP Ports” under Security in the menu on the Advanced Configuration
page.
9 Select if the port should be closed (disabled) or open (enabled) in the NetBIOS
(UDP Port 137)
drop-down list.
10 Click “Activate”.
3.4.3 Fragmented TCP Packets
You can determine if the module shall allow that IP packets is broken into several
smaller packets, which then can be transmitted an reassembled at the final destination.
If the IP network only allows packets with 1500 bytes, the packets will be dropped if not
fragmenting is allowed. If fragmentation is allowed in the IP network, the parameter
needs to be enabled in module.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration in the menu on the
Configuration page.
3 Select “IP Ports” under Security in the menu on the Advanced Configuration
page.