Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
11
3. General
2 Select Other Settings > Advanced Configuration in the menu in the on the
Configuration page.
3 Select “Password Policy” under Security in the menu on the Advanced
Configuration
page.
4 Select password policy.
5 Click “Activate”.
It is also possible to select previous or factory default settings.
3.4 System Security Settings
Security settings, such as not allowing HTTP and FTP access, disabling NETBIOS and
increasing the security by using Certificates might be needed if required by the
customer.
3.4.1 Web Access Security Settings
You can determine if the WSG only should be accessed via HTTPS and FTPES to
establish a secure connection between your client and the WSG. Information sent
between the client and the WSG cannot be seen by any third-party. The HTTPS and
FTPES require a certificate.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration in the menu in the on the
Configuration page.
3 Select “Web Access” under Security in the menu on the Advanced Configuration
page.
4 Select if Secure Mode shall be enabled or not.
5 Click “Activate”
It is also possible to select previous or factory default settings.