Specifications

TD 92442EN
04 October 2013 / Ver. PB1
Installation and Operation Manual
OpenStage WL3 Wireless Service
97
16. Troubleshooting
Flashing patterns
16.4 Advanced Troubleshooting
The Advanced Configuration page (requires system administrator rights) includes
advanced troubleshooting. Snapshots of selected logs or a complete log can be
viewed.
1 Click “Configuration” on the start page.
2 Select Other Settings > Advanced Configuration in the menu on the
Configuration
page.
3 Click the “Troubleshoot” button on the Advanced Configuration page.
4 In the left menu on the Troubleshoot page you can view logs and find detailed
information about the system.
• Specify Information to Log
Demonstration
Mode:
Demonstration Mode is activated by pressing the Mode
button for 10 seconds. The module will then run with full
functionality for 2 hours, it then returns to the configured
license! If it works in Demonstration Mode and not in normal
operation you probably have a license problem.
Active faults: Refer to 4.3.1 Active Faults on page 20.
Fault logging: Refer to 4.3.4 Fault Log on page 21 and 4.3.5 Administer the
Fault Log on page 22.
System Information: See 16.4 Advanced Troubleshooting below.
Red
Red
Blue
Blue
Yellow
Yellow
Status LED
Blue
Error/fault
Starting up/ shutting down
Status OK
Demonstration mode
Feedback (1 second)
Mode LED
Blue
Blue
Boot mode
Waiting for automatic
startup (1 minute)
Warning
Troubleshoot mode and
during firmware upgrade
Mass storage mode
Yellow
Yellow
Power LED
Red
Red
Blue
* also used if the Power parameter conflicts
with the actual setup.
Closing down caused by
low voltage
Power OK
Low voltage*
Mode LED
Blue
Indicates that manual confirmation is required
Blue
Yellow
Status LED
Blue
Confirmation is done and
setting can be activated
Secured settings
Power