Specifications

TD 92442EN

04 October 2013 / Ver. PB1

Installation and Operation Manual

OpenStage WL3 Wireless Service

2. Installation and Configuration Steps

Figure 2. Initial installation and configuration.

NOTE: The installation of the products hardware is described in the Installation Guide

for WSG.

After installing the hardware, the basic configuration is easily made using the Setup

Wizard. The setup wizard includes all basic settings needed to get the WSG up and

running.

2.1 Information required for the Setup

Make sure the following information is available:

• MAC address – found on a label on the WSG’s rear side and in the application’s

GUI in the Setup Wizard.

• The module key – found on the license certificate or on the WSG’s rear side

• Network parameters – ask your network administrator

• License number – found on the license certificate

• IP address to connected system (if connected via IP)

• LDAP properties, if an LDAP server is used for Central Phonebook requests

(optional)).

2.2 Accessing the WSG

2.2.1 Getting Started

When accessing the WSG the first time, follow the instructions in the Getting Started

and safety Leaflet PM000021, or the Installation Guide for WSG.

NOTE: The IP address must not change during operation because renew of IP address

via DHCP is not handled. Other equipment connected to this product also

expects a fixed IP address in some cases. If the IP plan is changed, this product

must be restarted to update the IP address. Otherwise the system will not

function properly.

2.3 Basic Configuration Steps

Figure 3. The Setup Wizard.

Gather information

needed for the

basic conﬁguration

Set basic

conﬁguration using

the Setup Wizard

Conﬁgure optional

settings

Install the

hardware

Add Phonebook

entries