Specifications

Handset Configuration
Location
A31003-M2000-M100-1-76A9, 11/2012
6-40 OpenStage WL 3 / WL 3 Plus, Administration Manual
• Ekahau RTLS Solution
In order to use the Ekahau RTLS solution, the handset must have the Ekahau
license (see Section 5.1.7, “Upgrade Handset Functionality using License”,
on page 5) and also be configured.
6.14.1 Configure Handset for Cisco/Ekahau RTLS
Solution
1. Select Location > Common.
2. In the Location scanning drop-down list, select “Enable“.
3. In the Scanning interval
1
field, set the time between the scanning periods.
4. In the Scans per scanning period
1
drop-down list, select how many scans that
should be performed during each scanning period.
If the Ekahau RTLS solution is used, also perform the steps 5 - 8.
5. Select Location > Ekahau.
6. In the EKAHAU license drop-down list, select “Yes“. Additional parameters are
shown.
7. In the IP address field, enter the IP address to the Ekahau location appliance.
8. In the Listening port field, enter the port the location appliance is listening to.
1. Note that close scanning periods, and frequently scans per period, will shorten the battery time.