Specifications

Handset Configuration
Location
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 6-39
Tip: For more information about the PTT function, see also User Manual for the
WL 3 / WL 3 Plus Handset.
NOTE: If Music on Hold (MOH) is used in the system it can affect an ongoing
PTT group call. If someone in the group conference answers another incoming
call, MOH will be played for the whole group.
1. Select Push-To-Talk > X (where X represents 1-10).
2. In the Session name field, enter a name to identify the PTT session.
3. In the Group number field, enter the number to the PTT conference group.
4. In the Display text field, enter a text to be shown in the display during the PTT
session.
5. In the PTT session signal drop-down list, select the indication of the PTT
session.
6. In the Conference number field, enter the phone number to the conference
bridge.
7. In the Answer mode drop-down list, select the answer mode for the PTT
session.
8. In the Speaker mode drop-down list, select the speaker mode for the PTT
session.
9. A Service must be configured to access the PTT session from the handset. If
not configured, continue with Section 6.12.2, “Services”, on page 37.
6.14 Location
NOTE: Applicable to WL3 Plus only.
Two types of location are supported, either a basic location solution that gives an
approximate location using Access Point (AP) location, or a personal security
solution that gives a more accurate location using a third-party Real-Time
Location System (RTLS) solution.
The following RTLS solutions are supported:
• Cisco RTLS Solution
In order to use the Cisco RTLS solution, a Cisco Mobility Services Engine
must be used and configurations in the handset are required.