Specifications

Handset Configuration
Push-To-Talk (PTT) Group Call
A31003-M2000-M100-1-76A9, 11/2012
6-38 OpenStage WL 3 / WL 3 Plus, Administration Manual
3. In the Service name, enter the name of the service to be displayed in the
handset’s Service menu.
4. Select the service to be used:
• Phone Call
• Send a message to predefined number (prompt for the message text)
• Send data to message service centre (predefined data and/or prompt for
the data)
• Edit alarm data
• PTT
5. In the Service user data field, enter the data to be sent/dialed when using the
service.
NOTE: This field is not applicable for PTT.
6. In the Service prefix for user data field, enter the prefix for the service user data
(if needed).
7. In the Service index field, enter the corresponding index used for PTT. For
example, if PTT group 1 is configured (located under Push-To-Talk > 1), the
service index must be set to 1.
NOTE: This field is only applicable for PTT.
If the PTT is not configured, continue, with Section 6.13, “Push-To-Talk (PTT)
Group Call”, on page 38.
Tip: It is also possible to configure soft keys to reach services quickly, see Section
6.5.12, “Short cuts”, on page 16.
6.13 Push-To-Talk (PTT) Group Call
NOTE: Applicable for WL3 Plus only.
To be able to configure a PTT session, the following must be known:
• The group number to the PTT group (defined in the ).
• The phone number to the conference bridge.