Specifications

Handset Configuration
Alarm Settings
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 6-27
1. Select Alarm > Common.
2. In the Stored alarm data field, enter data to be sent along with an alarm
(optional).
3. In the Indicate initiated Alarm drop-down list, select one of the following:
• On - The handset will beep and the LED will flash twice when an alarm is
initiated.
• Off - The handset will not indicate when an alarm is initiated.
4. In the Disable backlight during alarm drop-down list, select one of the following:
• Yes - The display backlight will be left unchanged for 30 seconds after
alarm
• No - The display will light up after an alarm.
6.8.2 Push Button Alarm
1. Select “Alarm“.
2. Select “Multiple-press“ or “Long-press“.
3. In the Alarm type for multiple press drop-down list or Alarm type for long press
drop-down list, select “Push button alarm 1“.
4. In the Number for automatic call after alarm field, enter the number to be called
after an alarm has been activated (optional).
5. In the ALS drop-down list, select “Yes“ if an Acoustic Location Signal shall
sound when the alarm has been activated.
6. In the Text indication for alarm on multiple press field or Text indication for alarm
on long press, enter the text to be displayed in the handset when the alarm has
been activated.
7. In the Mode for automatic call after alarm drop-down list, select one of the
following:
• Monitor - The loudspeaker is muted and the microphone is on.
• Loudspeaker - The loudspeaker is turned on.
• Ordinary - The loudspeaker is turned off.
6.8.3 Test Alarm
1. Select “Alarm“.
2. Select “Multiple-press“ or “Long-press“.