Specifications

Handset Configuration
Messaging Settings
A31003-M2000-M100-1-76A9, 11/2012
6-24 OpenStage WL 3 / WL 3 Plus, Administration Manual
needs to close the current displayed message to show the next message in the
queue. In this case, the message received at 14:02. The closed message will be
indicated as a read message in the Messaging Inbox.
Example 2
This example describes the message handling with the following message
settings:
• TTP= 20 seconds
• TTR= Close manually
Tip: It is recommended to use these settings if the user shall not be interrupted
during 20 seconds while reading a message, unless a message with higher
priority is received. When the user has read a message, its priority is no longer
important, that is when TTP expires.
Figure 2
In Figure 2, a message with prio 2 is received and displayed in the handset, TTP
for the message is started.
After 10 seconds, a second message with priority 1 is received and displayed
while the message with priority 2 is put in the queue. TTP for the message with
priority 2 is paused, and TTP for the message with priority 1 is started.
After 20 seconds, TTP expires for the message with prio 1 and the message is
placed in the queue. The message with priority 2 is shown again and its TTP
continues.
TTP expires after 10 seconds for the message with priority 2. In this case, all
messages have been shown 20 seconds each, and the oldest shown message
with the highest priority is displayed (in this case, the message with priority 1).
The handset does not indicate when it shows the message again, since it already
has been shown and indicated once. The message with priority 2 is placed in the
queue.
Example 3
This example describes the message handling with the following message
settings:
• TTP= 20 seconds
Prio 2
13:59
Prio 2
13:59
Prio 2
13:59
Prio 2
13:59
Prio 2
New messages
10 s.
Prio 2
TTP paused
20 s.
Prio 1
TTP expired
Prio 1
TTP expired
10 s.
Prio 2
TTP expired
Prio 1
New messages
Prio 2
TTP
continues
Prio 1
TTP started
Prio 2
TTP started