Specifications

Handset Configuration
Handset Settings
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 6-13
• Predefined number – a predefined number will be called (if selected,
continue with step 3)
3. If needed, in the Predefined number field, enter the number to be dialled when
the headset button is pressed.
6.5.5 In Charger Behavior
The handset behavior when placed in a charger can be configured.
In charger action
1. Select Device > Settings.
2. In the In charger action drop-down list, select one of the following:
• No action - no action will be performed when handset is placed in charger
• Switch off - the handset will be switched off when placed in charger
• Sound off - the handset will be silenced when placed in charger.
• Change profile (WL3 Plus only) the handset will change profile when
placed in charger.
- In the Change profile in charger drop-down list, select the profile to be
used.
- If needed, configure the selected profile, see Section 6.5.6, “Configure
Profiles”, on page 13.
Clear lists in charger
1. Select Device > General.
2. In the Clear lists in charger drop-down list, select one of the following:
• On - message lists and call lists will be deleted when handset placed in
charger
• Off - no action will be performed when handset placed in charger.
6.5.6 Configure Profiles
It is possible to set up an own profile for incoming calls, message alerts,vibrating
alerts, key sound etc. This can be useful when there are many users on the same
handset, and they want different sound profiles. It can also be used for temporary
settings, for example while in a meeting, incoming calls should be silent.
Profiles are configured via parameters in the “Profiles“ folder.