Specifications

Handset Configuration
Handset Settings
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 6-9
5. In the EAP authentication user name field, enter the user name for EAP
authentication.
6. In the EAP authentication password field, enter the password for EAP
authentication.
6.4.6 EAP-TLS
Select EAP-TLS if a client certificate is to be used for authentication. To select
EAP-TLS as the authentication method, do the following:
1. Ensure that the handset is online in PDM.
2. Import the certificate by do the following:
• In the Numbers tab, right-click the handset’s number and select “Edit
certificates“. An Edit certificate window opens.
• In the Root tab and Client tab, click “Edit“ and select the certificates to
import. Click “Close“.
3. Select Network > Network A (B, C, or D).
4. In the Security mode drop-down list, select “EAP-TLS”.
5. In the EAP client certificate drop-down list, select the client certificate to use.
6.5 Handset Settings
This section describes specific settings for the handset that can be changed using
the keypad on the handset, and/or can be set in the PDM/WSG to assist the user
or to set the initial value when the handset is commissioned.
General Settings Keypad
*
PDM
Section 6.5.1, “Automatic key lock”, on page 10 xx
Section 6.5.2, “Phone lock”, on page 11 xx
Section 6.5.4, “Headset type”, on page 12 xx
Section 6.5.3, “Audio adjustment”, on page 11 x
**
x
Section 6.5.12, “Short cuts”, on page 16 xx
Section 6.5.6, “Configure Profiles”, on page 13 xx
Section 6.5.8, “Battery Warning”, on page 15 xx
Section 6.5.5, “In Charger Behavior”, on page 13 x
**
x
Section 6.5.9, “Shared Phone”, on page 15 x
Telephony
Section 6.9.8, “Message Centre Number”, on page 33 x
Table 2