Specifications

Handset Configuration
Network Settings
A31003-M2000-M100-1-76A9, 11/2012
6-6 OpenStage WL 3 / WL 3 Plus, Administration Manual
• All
• 1,6,11
• Advanced
Advanced: 802.11 Channels
Defines which 802.11 channels to use. Only used if the parameter in the 802.11b/
g/n channels, or 802.11a/n channels is set to “Advanced“.
NOTE: It is not possible to scan channels in 802.11b/g/n and 802.11a/n simulta-
neously.
1. Select Network > Network A (B, C, or D).
2. Enter channels to scan in a comma-separated list, for example 1,6,11 (the
order has no impact; 11,6,1 will give the same result).
6.3.5 Transmission Power
This is the transmission power the handset will use when transmitting data to the
WLAN system. If “Automatic” (default) is used, the transmission power is adapted
according to 802.11h, CCX or maximum possible.
1. Select Network > Network A (B, C, or D).
2. In the Transmission power drop-down list, select one of the following:
• Automatic
• 0 dBm
• 5 dBm
• 11 dBm
• 14 dBm
• 20 dBm (max)
6.3.6 IP DSCP for Voice/Signaling
Differentiated Services Code Point (DSCP) defines which value to use for
outgoing voice and signaling traffic. The DSCP value is used for QoS on the LAN.
The settings in the handset must agree with the settings in the system, otherwise
it will result in bad voice quality.