Specifications

Handset Configuration
Network Settings
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 6-5
1. Select Network > Network A (B, C, or D).
2. In the 802.11 protocol drop-down list, select “802.11a/n“.
3. In the 802.11a/n channels drop-down list, select one of the following:
NOTE: The selected World Mode Regulatory Domain determines which
channels to be used. SeeSection 6.3.4, “Bands and Channels used by WiFi
a-radio”, on page 5.
• All
• Non DFS
• UNII-1
• UNII-3
• UNII-1, UNII-2
• UNII-1, UNII-2, UNII-3
• UNII-1, UNII-2, UNII-2 Extended
• Advanced
Bands and Channels used by WiFi a-radio
802.11 b/g/n Channels
Defines which 802.11b/g/n channels to use. It is recommended to use the default
value “1,6,11“. If set to “All”, all channels are scanned for access points which
decreases the WLAN performance. Select “Advanced“ only if the channels shall
be set in the parameter Advanced: 802.11 channels.
1. Select Network > Network A (B, C, or D).
2. In the 802.11 protocol drop-down list, select “802.11b/g/n“.
3. In the 802.11b/g/n channels drop-down list, select one of the following:
Frequency band Channels
Non DFS 5.150 - 5.250 MHz,
5.725 - 5.845 MHz
36,40,44,48
149,153,157,161, 165
UNII-1 5.150 - 5.250 MHz 36,40,44,48
UNII-2 5.250 - 5.350 MHz 52,56,60,64
UNII-2
Extended
5.470 - 5.725 MHz 100, 104, 108, 112,116, 120, 124, 128, 132,
126, 140
UNII-3 5.825 - 5.835 MHz 149,153,157,161
Table 1