Specifications

Handset Configuration
Network Settings
A31003-M2000-M100-1-76A9, 11/2012
6-4 OpenStage WL 3 / WL 3 Plus, Administration Manual
6.3.2 Voice Power Save Mode
The voice power save mode is used during calls. NONE is recommended to
obtain optimal voice quality. U-APSD uses less power but is more sensitive to
network disturbances.
If supported by the infrastructure U-APSD is the preferred choice and multiple the
talk time more than 4 times compared to NONE mode.
1. Select Network > Network A (B, C, or D).
2. In the Voice power save mode drop-down list, select one of following:
• NONE
• U-APSD
6.3.3 World Mode Regulatory Domain
There is a set of regional rules for the world mode settings and the a-band that
the handset complies to. The preferred and the default setting is “World mode
(802.11d)”. The handset gets its regulatory settings from the AP. If this is not
supported by the AP, then this has to be set in the handset as follows:
1. Select Network > Network A (B, C, or D).
2. In the World mode regulatory domain drop-down list, select one of the following:
• World mode (802.11d) (default)
• ETSI
• Japan
• USA
6.3.4 Radio and Channel Selection
The handset supports the 802.11a/n radio and 802.11b/g/n radio, but it cannot
use the 802.11a/n radio and the 802.11b/g/n radio simultaneously. The radio
determines which channels that can be used.
802.11 a/n Channels
Defines which 802.11a/n channels to use. It is recommended to use the value
“UNII-1“. Select “Advanced“ only if the channels shall be set in the Advanced:
802.11 channels parameter, see Section 6.3.4, “Advanced: 802.11 Channels”, on
page 6.