Specifications

Handset Configuration
IP Address Settings
A31003-M2000-M100-1-76A9, 11/2012
6-2 OpenStage WL 3 / WL 3 Plus, Administration Manual
6.1.2 Change Name of Network
The name is shown when selecting network in the handset.
1. Select Network > Network A (or B, C, or D).
2. In the Network name field, enter the name of the network.
6.1.3 Enable Switch between Networks
The handset may be configured to switch between networks on the site.
1. Find parameter Network > General > Auto-switch network, and select
“Enable”.
Parameter Auto-switch network time-out appears. This parameter defines the
time before the handset tries to connect with the next included network.
2. Enter a value in seconds for parameter Auto-switch network time-out.
3. For the networks that should be included in the auto-switch network:
Find parameter Network > Network A (B, C, D) > Include in auto-switch
network, and select “Yes” to enable switch to Network A (B, C, D).
6.2 IP Address Settings
The IP address settings can be configured in two ways.
• The handset can configured to receive an IP address automatically from a
DHCP server, see Section 6.2.1, “Automatic IP Address Settings”, on page 2.
• If no DHCP server is used, a unique IP address must be entered manually for
each handset, see Section 6.2.2, “Static IP Address (Manual) Settings”, on
page 3.
6.2.1 Automatic IP Address Settings
1. Select Network > Network A (or B, C, D).
2. In the DHCP mode drop-down list, select “Enable”.
The Phone IP address, Subnet mask and Default gateway are automatically set
up.