Specifications

Maintenance

Update Parameters via WSG

A31003-M2000-M100-1-76A9, 11/2012

5-16 OpenStage WL 3 / WL 3 Plus, Administration Manual

5.4 Update Parameters via WSG

This section describes the general procedure on how to change/update

parameters using the WSG. The update starts when the handset is idle and will

not interrupt an ongoing call.

NOTE: Only select the parameters that are changed, if all parameters are

selected, the system performance decreases.

1. Open the WSG.

2. Create a new template with only the parameters that shall be changed.

3. Select the numbers that should be updated and apply the template.

The handsets are automatically updated from the WSGand might be

restarted depending of which parameters that are changed.

5.5 Perform a Security Upgrade via WSG

This section describes how to perform an update/change of the WLAN password/

authentication using the WSG.

NOTE: Change settings in the handset before change settings in the AP. Else,

synchronization of new settings to the handset settings cannot be performed.

Tip: Leave one access point with the old configuration to allow switched off

handsets to receive the updates when they are turned on. Bring the handset to

that APs coverage area.

1. Open the WSG.

2. Create a new template with the new security settings.

• Security mode

3. Apply the new template to the handsets.

The handsets are automatically updated from the WSG and restarted.

NOTE: At this time, the handsets have no access to the WLAN system.

4. Change the security settings for the access points.

1. All required settings for the WLAN. For example User name, Password, Regulatory domain etc.