Specifications

Maintenance
Replacement of Handsets
A31003-M2000-M100-1-76A9, 11/2012
5-12 OpenStage WL 3 / WL 3 Plus, Administration Manual
• WSG settings
1
(located under Device > WSG)
7. Remove the handset from the Desktop Programmer (DP1) cradle. The
handset might be restarted depending on parameter changes.
8. Enter the number and the password
2
(if any). Press “Login”.
The spare handset is automatically updated from the WSG and might be
restarted depending on the parameter changes. The last stored settings for the
broken handset in the WSG has been transferred to the new handset.
Replace and Move License using PDM and WSG
The broken handset and the spare handset do not have the same device type
and/or have the same functionality license.
In order to move the licenses to the spare handset, it must be an unlicensed WL3.
To check that the handset is unlicensed, press *#34# in idle mode and select
“License“. Only WL3 must be displayed here.
1. Make sure that the broken handset is saved in the Device Manager (indicated
by a in the Saved column. If not, in the Numbers tab, right-click the broken
handset and select “Save“.
2. Switch off the broken handset to make it offline.
3. Open the PDM.
4. Put the unlicensed spare handset (WL3) in the Desktop Programmer (DP1)
cradle.
5. Run the template with the basic network settings containing (see Section 4.4,
“Configure a Handset with a Template”, on page 7):
• Network settings
1
(located under Network > Network A, B, C, or D)
• VoIP settings
2
(located under VoIP)
• WSG settings
3
(located under Device > WSG)
6. Remove the handset from the Desktop Programmer (DP1) cradle. The
handset is restarted.
7. Enter the number and the password
3
(if any). Press “Login”.
8. Make sure that the spare handset is saved in the Device Manager (indicated
by a in the Saved column. If not, in the Numbers tab, right-click the spare
handset and select “Save“.
9. Switch off the spare handset to make it offline.
10. Switch on the broken handset to make it online.
1. IP address and password (if any) to the WSG.
2. The password is only required if the “Password“ parameter is set.