Specifications

Maintenance

Replacement of Handsets

A31003-M2000-M100-1-76A9, 11/2012

OpenStage WL 3 / WL 3 Plus, Administration Manual 5-11

The spare handset is automatically updated from the WSG and restarted. The

last stored settings and licenses for the broken handset in the WSG has been

transferred to the spare handset.

5.2.3 Replacement of the Handset with PDM and WSG

If the spare handset to be used must be factory reset or no network template has

been applied, a PDM is needed to apply the network template to the spare

handset. When the network template is added, the handset can log on to the

Device Manager.

There are two different replacement procedures as follows:

• If the broken handset and the spare handset have the same device type and

functionality license, seeSection 5.2.3, “Replace without Move Licenses

using PDM and WSG”, on page 11.

• If the broken handset and the spare handset have not the same device type

and/or functionality license. The license must be moved to the spare handset,

see Section 5.2.3, “Replace and Move License using PDM and WSG”, on

page 12.

Replace without Move Licenses using PDM and WSG

Both the broken handset and the spare handset must be of the same device type

and have same functionality license.

1. In the handset, press *#34# in idle mode and select “License“ to check that

both handsets have same device type and licenses.

2. Make sure that the broken handset is saved in the Device Manager (indicated

by a in the Saved column. If not, in the Numbers tab, right-click the broken

handset and select “Save“.

3. Switch off the broken handset to make it offline.

If the spare handset is not prepared with the basic network settings, also perform

the steps 4 - 7.

4. Open the PDM.

5. Put the spare handset in the Desktop Programmer (DP1) cradle.

6. Run the template with the basic network settings containing (see Section 4.4,

“Configure a Handset with a Template”, on page 7):

• Network settings

(located under Network > Network A, B, C, or D)

• VoIP settings

(located under VoIP)

1. All required system settings for the WLAN. For example SSID and Security mode.

2. VoIP protocol, Gatekeeper IP address or SIP Proxy IP address used to access the PBX.