Specifications

Maintenance

Handset

A31003-M2000-M100-1-76A9, 11/2012

5-2 OpenStage WL 3 / WL 3 Plus, Administration Manual

5. Click “OK“.

6. Set the following network parameters:

• Network settings

(located under Network > Network A, B, C, or D)

• VoIP settings

(located under VoIP)

• Syslog settings

(if any) (located under Device > General)

• WSG settings

(if any) (located under Device > WSG)

7. Click “OK“ to save the template.

Apply Template to a Handset without a Number

1. Put the handset in the Desktop Programmer (DP1) cradle.

2. In the Found Device Wizard window, select the “Run template“ option.

3. Click “Next >“.

Only templates with a parameter version matching the selected handset will be

shown.

4. Select the template that shall be applied and click “OK“.

The template is applied. The number of parameters in the template will affect the

time it takes to apply the template to the selected handset.

5. Switch off the handset when User name and Password are displayed.

Tip: If the handset shall replace a broken handset, continue with Section 5.2.2,

“Replacement of Handset with WSG”, on page 9.

5.1.2 Upgrade Handset Software

NOTE: Pay attention to the software Release Notes before changing the

software.

The handset software can be upgraded over the air using Centralized Device

Management (WSG) or a TFTP server, or by cable using PDM.

1. All required system settings for the WLAN. For example SSID and Security mode.

2. For example VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the

PBX.

3. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.

4. IP address and password (if any) to the WSG.