Specifications

Maintenance
Handset
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 5-1
5 Maintenance
5.1 Handset
In an existing VoWiFi system it is important to be able to replace handsets, install
new handsets and exchange faulty handsets. The recommended procedure is to
use a template with basic network settings for log in, created in the PDM, and then
get the rest of the settings that were created by the templates in Device Manager
in WSG
Another important matter is to be able to upgrade system parameters and
security settings in the handsets. These upgrades are preferably done in the
WSG if available.
If PDM and WSG are used, do one of the following:
• If you want to install new handset, see Section 4.1, “Installation with Central
Device Management (WSG)”, on page 1.
• If you want to create spare handsets to be used when broken handsets need
to be replaced later on, see Section 5.1.1, “Configure Spare Handsets without
a Number in Large Systems”, on page 1.
If only PDM is used, do one of the following:
• If you want to install new handset, see Section 4.2, “Installation without
Central Device Management(WSG)”, on page 5.
• If you want to replace a broken handset, see Section 5.2.4, “Replacement of
Handset with PDM Only”, on page 13.
5.1.1 Configure Spare Handsets without a Number in
Large Systems
In large systems where WSG is used, it is recommended to configure a couple of
spare handsets without a number in order to quickly replace a broken handset
later on.
Create a Template
1. Open PDM.
2. Select the Templates tab and click “New“. The New template window is opened.
3. In the Device type and Parameter version drop-down lists, select the matching
device type and parameter version for the spare handset to use, respectively.
4. In the Name field, enter a descriptive name of the template.