Specifications

Installation of WLAN Handsets
Configure a Handset with a Template
A31003-M2000-M100-1-76A9, 11/2012
4-10 OpenStage WL 3 / WL 3 Plus, Administration Manual
Some parameters are user specific. If it is decided to apply this type of
template to several handsets, it is recommended to exclude the following
parameters:
• User display text - A text string displayed in idle mode. The parameter is
located directly under “Settings“.
• Phone lock PIN code - The security code used to unlock the keypad. The
parameter is located under Settings > Locks.
• Endpoint ID - The identity/name of the user registered in the PBX. The
parameter is located under VoIP > General.
5. Click “OK“.
4.4.5 Synchronizing a Handset with PDM
After installing and saving a handset, it will be synchronized each time it is
connected to the PDM. The synchronization transfers parameter changes
between the handset and the PDM and vice versa as follows:
• If a parameter has been changed in the handset, it will be transferred to the
PDMWSG.
• If a parameter has been changed in the PDMWSG while the handset was
disconnected, it will be transferred to the handset.
If the same parameter has been changed in both the PDMWSG and the handset,
the value in PDMWSG will be transferred to the handset.
4.4.6 Configure Handset without Saving It in PDM
It is possible to configure a handset without saving it in the PDM. An unsaved
handset do not have the symbol in the Saved column. The settings in the
handset can be synchronized and saved in the PDM later on. However, it is
recommended to save the handset in PDM if backup is needed. For example
when a handset needs to be replaced.
1. Put the handset in the Desktop Programmer (DP1) cradle.
2. Open PDM.
3. In the Numbers tab, select the unsaved handset you want to configure.
4. Select Number > Edit parameters.
5. The Edit parameters window is opened. Edit the parameters of the handset and
click “OK“.