Specifications

Installation of WLAN Handsets

Installation using the Handset’s Admin Menu

A31003-M2000-M100-1-76A9, 11/2012

OpenStage WL 3 / WL 3 Plus, Administration Manual 4-7

4.3 Installation using the Handset’s Admin Menu

It is possible to install a handset using its Admin menu. This is useful when no

PDM or WSG is available and the handset needs to be installed quickly.

NOTE: It is only possible to configure the basic settings via the Admin menu.

1. There are two options to access the Admin menu:

• If the handset has been factory reset or not been configured; in idle mode,

enter 40022.

• If the handset has been configured; press “Menu“, select “Settings“ and

enter 40022.

2. Set the following parameters:

• Network settings

(located under Network setup)

• VoIP settings

(located under VoIP)

• WL3 settings

(if any) (located under WL3)

• Syslog settings

(if any) (located under Syslog)

• Add license key (if any) (located under Enter license key)

4.4 Configure a Handset with a Template

It is possible to select a handset in the PDM and directly change one or more

configuration parameters. By using a template, the same configuration can easily

be applied to many handsets simultaneously. Templates are also an efficient way

to give good control over which changes that are applied to each handset.

Templates enables configuration of all aspects of a handset from sound volume

to keypad short cuts.

Your supplier can provide example templates for different PBX:s. The handset will

have full functionality towards the PBX even without such a template. By using

such a template, though, the handset will be customized for that PBX with menu

options for PBX specific functions.

1. All required system settings for the WLAN. For example SSID and Security mode

2. VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.

3. IP address and password (if any) to the

WSG.

4. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.