Specifications

Installation of WLAN Handsets
Installation without Central Device Management(WSG)
A31003-M2000-M100-1-76A9, 11/2012
4-6 OpenStage WL 3 / WL 3 Plus, Administration Manual
8. Create another template (see Section 4.4.1, “Create a template”, on page 8)
with the common handset settings applicable to all handsets (exclude the
network parameters and used security settings). Example of parameters
settings:
• VoIP settings
1
(located under VoIP)
• Software TFTP IP address (if any) (located under Device > General)
• Syslog settings
2
(if any) (located under Device > General)
In addition, settings for hiding menu items in the display, certain level of ring
signal and vibrators etc. can also be configured.
9. Apply the network settings template to the handset, see Section 4.4.2, “Apply
a Template to a Handset with a Number”, on page 8.
10. Apply the common settings template to the handset, see Section 4.4.2, “Apply
a Template to a Handset with a Number”, on page 8.
11. Put the handset in the Desktop Programmer (DP1) cradle.
12. In the Device Wizard window, select “Associate with number“ and press “OK“.
13. Select the handset to associate with. Press “OK“.
The number and parameter settings saved in the PDM will now be synchronized
with the handset. In addition, the handset’s Device ID will also be synchronized
with the number in the PDM.
If certificates must be used to access a VoWiFi system, also perform the steps 14
- 19.
14. In the Numbers tab, right-click the handset’s number and select “Edit
certificates“. An Edit certificate window opens.
15. In the Root tab and Client tab, click “Edit“ and select the certificates to import.
Click “Close“.
16. In the Numbers tab, right-click the handset’s number and select “Edit
parameters“.
17. Select “Network X“ (X represents A, B, C, or D).
18. In the Security mode drop-down list, select “EAP-TLS“.
19. In the EAP client certificate drop-down list, select the client certificate to be
used. Click “OK“.
20. Remove the handset when synchronization is finished.
Repeat the steps 11-13, 20 (if needed, perform the steps 14-19) for all handsets.
2. All required system settings for the WLAN. For example SSID and Security mode.
1. VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the PBX.
2. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.