Specifications
Installation of WLAN Handsets
Installation without Central Device Management(WSG)
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 4-5
3. Put the handset in the Desktop Programmer (DP1) cradle.
4. Run the template. See Section 4.4.3, “Apply a Template to a Handset without
a Number”, on page 9.
5. Remove the handset when synchronization is finished.
6. Enter the Number and the password
1
(if any). Press “Login“.
Settings that were stored for the handset in the Device Manager in WSG will
now be downloaded to the handset. This can, for example, be unique soft- or
hot keys that have been prepared earlier. When the settings have been
downloaded to the handset, it might be restarted depending on the parameter
changes.
7. Repeat step 3 – 6 for all handsets.
4.2 Installation without Central Device Management(WSG)
In a small VoWiFi system, the administration can be handled using only the PDM.
The synchronization is in this case not handled automatically by the system when
a handset’s parameters are changed in the PDM. When the parameters have
been changed in PDM, each handset must be placed in the Desktop Programmer
(DP1) cradle connected to the administrator’s computer in order to synchronize
the parameters with the handset.
1. Open the PDM.
2. In the Numbers tab, click “New“. The New numbers window is opened.
3. In the Device Type and Parameter version drop-down lists, select the matching
device type and the parameter version for the handset to be use, respectively.
4. In the Prefix field, enter the numbers’ prefix (if needed).
5. Create a range of numbers by selecting the “Range“ option. Enter the start
call number and the end call number in the fields, respectively.
6. Click “OK”.
7. Create a network settings template (see Section 4.4.1, “Create a template”,
on page 8) with the following network parameters:
• Network settings
2
(located under Network > Network A, B, C, or D)
Note: The parameters in this template should be identical to the parameters in the
network template created in the WSG.
* All required system settings for the WLAN. For example SSID and Security mode.
** IP address and password (if any) to WSG.
1.The password is only required if the “Password“ parameter is set.