Specifications

Installation of WLAN Handsets

Installation with Central Device Management (WSG)

A31003-M2000-M100-1-76A9, 11/2012

4-2 OpenStage WL 3 / WL 3 Plus, Administration Manual

4.1.1 Create a Network Template in the WSG

Create one template that contains the network parameters (also include the

security settings). Besides the network parameters, additional parameters might

also be set, for example VoIP settings and IP address to WSG. The template must

be created to prevent the WSG from restoring the parameters to default during

the first synchronization.

NOTE: Only select the parameters that are changed, if all parameters are

selected the system performance decreases.

1. Open a web browser and enter the address to the WSG.

2. Click “Device Manager“. You might be prompted to log on the Device

Manager.

3. Select the Templates tab and click “New“. The New template window is opened.

4. In the Device type and Parameter version drop-down lists, select the

corresponding device type and parameter version to use, respectively.

5. In the Name field, enter a descriptive name of the template.

6. Click “OK“.

7. Set the following network parameters:

• Network settings

(located under Network > Network A, B, C, or D)

• VoIP settings

(located under VoIP)

• Syslog settings

(if any) (located under Device > General)

• WSG settings

(located under Device > WSG)

8. Click “OK“ to save the template.

NOTE: : See Working with Templates for tip on how to work with templates when

using both PDM and WSG.

1. All required system settings for the WLAN. For example SSID and Security mode.

2. For example VoIP protocol, Gatekeeper IP address or SIP proxy IP address used to access the

PBX.

3. The parameter “Syslog“ must be enabled in order to set the “Syslog IP address“.

4. IP address and password (if any) to the WSG.