Specifications

Programming the WLAN Handset
PDM
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual 3-1
3 Programming the WLAN Handset
This chapter describes how to configure handsets in three different ways:
• It is possible to configure the handset by inserting it into a DP1 Desktop
Programmer cradle connected via USB to the PDM.
• t is possible to configure the handset via over-the-air (OTA) using the Device
Manager in the WSG.
NOTE: This requires that the IP address to the WSG has been configured in
the handset. The IP address is configured using PDM or via the handset’s
Admin menu.
• It is possible to configure the basic network settings of the handset via its
Admin menu. See Section , “Administration”, on page 1 for more information
about the settings that can be made.
It is recommended to use the Device Manager in WSG to configure handsets in
a large system. The reason is that it enables to install, upgrade and configure a
large amount of handsets simultaneously. Another benefit is that the collection of
the handsets from the user is not needed.
The PDM enables configuration of one handset at the time inserted in the DP1
Desktop Programmer connected via USB to the administrator’s computer.
NOTE: It is recommended to use templates when configuring handsets. By using
a template, the same configuration can easily be applied to many handsets simul-
taneously.
3.1 PDM
The PDM runs on a PC and is used for configuring the handset as follows:
• Connect a DP1 Desktop Programmer cradle via USB to the computer running
PDM.
• Start PDM.
• Place the handset in this cradle connected to PDM.
For instructions on how to install and use the PDM, see Administration Manual for
Wireless Gateway Server.