Specifications

Configuring OpenStage WL3 Device to be used at OpenScape Voice (OSV)
Prerequisites
A31003-M2000-M100-1-76A9, 11/2012
OpenStage WL 3 / WL 3 Plus, Administration Manual B-1
B Configuring OpenStage WL3 Device to be used at
OpenScape Voice (OSV)
B.1 Prerequisites
1. Create all the subscribers using the OpenScape Voice Assistant.
2. Security > SIP Authentication needed if the Digest Authentication is turned on
the OSV.
3. Configure OpenStage WL3 according OpenStage WL3 configuration manual
Chapter 4 to 6.
Please consider the OSV numbering plan when defining the OpenStage WL3
numbers (chapter 4.1.3 or 4.2); the number, i.e. the Endpoint Number will be
later on the registration identity!
B.2 WL3 Steps
B.2.1 Setup TCP Subscriber
Numbers tab -> Right click on the Number you want to configure the parameters
and select Edit Parameters.
VoIP > General
1. Offer Secure RTP: No
2. Endpoint number: Subscriber Number ( Automatically populated)
– Endpoint ID: depending on OSV setup.
Registration identity and Authentication identity is the same:
Subscriber Number
– Authentication identity is different to Registration identity:
ID to be used for SIP authentication
VoIP > SIP
1. SIP Transport: TCP
2. Validate Server certificate: No
3. Outbound Proxy mode: No (Yes, if the subscriber is a Branch Subscriber)
4. Primary SIP Proxy: OSV SIP Signaling IP/FQDN