Operation Manual

197
MultiLine
There is no difference between multi-line calls and single-line calls when it
comes to recording calls. If recording has started, the call is recorded, otherwise
not. The recording status of a line continues as long as calls are connected to
this line.
For example, if line A is being recorded (initiated manually) and you switch to
line B or line A is placed on manual hold and you switch to line B, the recording
is ended and a partial recording saved.
If you disable recording for the call on line B (mode = manual or autostart) and
switch back to line A, the recording for line A is not started again.
The operating modes mentioned (All Calls, AutoStart or Manual) refer to the tele-
phone and are therefore the same for all lines.
Recording calls
Automatic call recording
This is the simplest mode. If you have accepted a call or called a subscriber and
the subscriber answers, the call is recorded automatically. Refer to
 page 196
to check which calls this can be.
As soon as the recording starts, you will see the recording symbol
| on the dis-
play and hear a beep (see also
 page 196).
You cannot pause the recording manually in this mode.
Manual call recording
Activating or deactivating call recording when the telephone is in idle
mode.
Prerequisite: Manual mode is selected. The recording button is configured and
indicates the status.
Press the Function key to activate – the LED lights up.
Or press the Function key shown to disable the option - the LED turns off.
The recording button also indicates the status change if you activated or deacti-
vated call recording using the Softkey.
ä Recording R
_
á Recording R
¤