Operation Manual

106
Open using the Softkey.
if nec.
j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
Paired devices are displayed. Start the search for new devices with the Softkey.
Start or set the pairing function on the Bluetooth device if appropriate.
Located devices are displayed. Repeat the search if appropriate with the Soft-
key.
If at least one new device was found, select the relevant Bluetooth device and
open with the Softkey.
Confirm the pairing prompt with the Softkey. The Bluetooth device is paired and
added to the list.
or
A pairing PIN is requested.
j Enter the pairing PIN and confirm with the Softkey. The Bluetooth device is
paired and added to the list.
Your OpenScape CP 600 is now "paired" with the Bluetooth device, but not yet
connected
 page 106.
Connecting/disconnecting a Bluetooth device
Prerequisite: At least one Bluetooth device is listed.
@ Press the key for the Main menu if appropriate.
Open using the Softkey.
Open using the Softkey.
if nec.
j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey. Paired devices are displayed.
$
User settings
-
_
$
Bluetooth
-
_
Paired devices
-
_
Add device
Õ
_
Add device
é
_
?
Headset
è
_
Accept
Q
_
©
Enter pairing PIN...
Q
_
Pairing is only performed the first time contact is established between a
Bluetooth device and your OpenScape CP 600. If the Bluetooth device is
successfully paired, no further access authorization checks are necessary.
Instead, each subsequent check uses the previously created link key.
Settings
_
$
User settings
-
_
$
Bluetooth
-
_
Paired devices
-
_
You receive a message that the OpenScape CP 600 is now visible for oth-
er Bluetooth devices while you are in this menu.