User guide

Putting the Handset into Operation 13

Putting the Handset into Operation

Removing the protective cover

Inserting/changing the batteries

The handset is supplied with two approved batteries. The batteries are supplied uncharged. They

are charged in the handset.

1. If attached: remove the attachment clip

Insert a screwdriver between the attachment clip and the battery cover (1) and force the attach-

ment clip outward (2) until it dislodges.

Also dislodge and remove the clip on the opposite side.

Remove the protective cover from the display be-

fore putting the handset into service.

Note:

• Please observe the safety notes on the back cover!

• Only use approved batteries

 Page 16!

• Always replace both batteries at the same time and only use two batteries of the same

type/ from the same manufacturer!

• Open the battery compartment in a dust-free environment only.

• Your telephone directory entries and all settings remain stored even if you remove the bat-

teries. The date and time settings will be reset.

• Only remove the batteries if they are defective. The battery’s life diminishes each time it

is removed.